Set up a BEAM-RN repeater node (Snape 1.0 and Standalone)
Snape 1.0 and StandaloneVersion 1.1 · 6 November 2026KC-04-006-S1
This guide is for Snape 1.0 and Standalone. Other versions: Snape 2.0.
BEAM-RN Repeater Node
The BEAM-RN (Repeater Node) has no sensor connector blocks and does not collect sensor data. Its sole purpose is to extend the Ackcio Mesh network, acting as a relay point to bridge the gap between sensor nodes that are too far from the Gateway or other nodes.
- No sensor wiring or sensor configuration is required.
- Simply install batteries, mount the node in the desired relay position, and commission it as a standard node in Nimbus.
- Once commissioned, the BEAM-RN will automatically join the mesh and start relaying data from child nodes.
- After commissioning, sync the repeater with the Gateway. See Syncing nodes with the Gateway.
Place the BEAM-RN where it can see both the Gateway (or an upstream node) and the isolated downstream nodes in the Network Test. It must have at least 2 visible neighbours in the Network Test before deployment, the same rule applies as for all other nodes.